Introduction to Arduino Course​
 

Classes are presented in both English and Afrikaans.

Suitable for ages 12+:

The introductory course is presented on Saturdays from 9:00 to 14:00 for 3 weeks. Each learner is given a kit that contains all the components used in the course. Each learner must bring along their own computer. This course is presented on the assumption that the learner has no experience in programming Arduino. The basic principles of electronic circuits used in the course will be covered.

Outcomes:

• Understanding of micro-controllers and their capabilities.

• Programming skills in Arduino language (based on C/C++.)

• Knowledge of Arduino board communications with computers, monitors, sensors and actuators.

• Skills with regards to prototyping an electrical circuit on a breadboard.

Computer Specifications:

Each learner must bring a long a computer with the following minimum requirements:

• Win 8 or later, 1.6GHz processor and 4GB of RAM.

• 600MB of free disk space for software installation.

Kit:

• ​Arduino Uno R3

• Communication cable for the Arduino used.

• All the required software.

• 1x Breadboard

• 1x Light Dependant Resistor (LDR)

• 1x Bright White LED

• 4x Coloured LEDs (Blue, Green, Yellow and Red)

• 5x 220Ω resistors

• 1x 10kΩ resistor

• 1x 1kΩ resistor

• 1x 100kΩ resistor

• 1x Pushbutton

• 1x 6 Volt DC motor

• 1x Flyback Diode

• 1x Potentiometer

• 1x Transistor

• 1x Battery holder

• 2x AA batteries

• Wires

Cost:

Total cost is R2660.  

• Kit : R660

• Day 1 : R500

• Day 2 : R500

• Day 3 : R500

• Day 4 : R500